BARBED HOSE CONNECTORS - 1/4 INCH
Raindrip produces these sturdy hose connectors. These fittings make connecting 1/4-inch hose easy.
Barbed Elbows - 1/4 inch - (Pack of 25) $6.25 
Barbed Straight Connector -1/4 inch - (Pack of 25) $6.25
Barbed Tee- 1/4 Inch - (Pack of 25) $6.25
|
BARBED HOSE CONNECTORS - 1/2 INCH
Raindrip produces these sturdy hose connectors. These fittings make connecting 1/2-inch hose easy. Use these with the Bulkhead Fittings listed on this page and you can insert them into buckets, reservoirs, etc. to serve as pump inlets or drain fittings.
Barbed Elbows -1/2 inch - (Pack of 25) $12.99
Barbed Straight Connectors - 1/2 inch - (Pack of 25) $12.99
Barbed Tees - 1/2 inch - (Pack of 25) $13.25
|
BULKHEAD FITTINGS (pack of 10 pcs.)
$8.00
Rubber grommets great for passing 1/2” barbed fittings through buckets, tubs, reservoirs, etc. Allows drain or pump hoses to be easily attached. Drill a 3/4" hole and push the rubber grommet into the hole. Insert one of the 1/2" barbed fittings (listed on this page). A water-tight seal is formed with the bucket. Pack of 10 pieces.
|
BLUE SHUTOFF PLUGS-(pack of 10)
$2.99
We use these Blue Shutoff Plugs to close off 1/2" barbed Tee's, Elbows and Straight connectors. Handy for closing off the end of 1/2" feed lines. Insert a 1/2" straight connector at the end of a feed line and push the Blue Plug over the open end. Plugs are removable.
|
EBB & FLOW FITTING KIT
$14.95
Kit contains premium inlet fitting and variable height standpipe as the drain or overflow fitting. Requires drilling of 1-1/4” holes to accept fittings. Barbed connection on the drain fitting requires 3/4” hose. Barbed connection on the inlet fitting requires 1/2’ hose to connect to the pump.
|
DRIPPERS
These drippers are virtually clog-free. Because the tubing controls the flow-rate, there's no drippers to change. Five-inch stake holds spaghetti tubing that delivers approximately two-gallons per hour. 18-inches of tubing included with each stake.
DRIPPERS - Pack of 10 $6.50
DRIPPERS - Pack of 100 $45.00
|
|
VINYL HOSE
Soft vinyl hose makes connections a snap. Use 1/2” tubing as a main feed line for the drippers listed above, connect them to 1/2” barbed fittings, or to pumps. The 1/4” hose is good for our 1/4" barbed fittings.
VINYL HOSE - ¼ inch (100 foot roll) $10.00
VINYL HOSE - ½ inch (100 foot roll) $40.00
|
|
|
FLOW CONTROL VALVES (for ½” hose)
$4.99
Nifty little inline valve controls flow to desired rate. Tapered to fit into 1/2” hose. Cut hose at desired point and insert valve. Polypropylene is impervious to chemicals.
|
|
FLOAT VALVES
$7.99
Used to maintain desired water level in master reservoirs to control multiple site hydroponic systems. Great for refilling reservoirs automatically from a water outlet or central reservoir. Plastic float with brass arm and barbed 1/2” fitting to attach hosing.
|
